Sta-Clene® Formula 940

Soil & Stain Repellent - One Quart

Item # 10143

  • Solvent-based fluorochemical formulation with exceptional oil, water and soil repellency
  • May be applied to Carpet, Rugs, Furniture, Stone and Marble
  • Contains no silicone.
  • Save money when you buy a case of 12

1 Case (12 Quarts)
  • Add to Cart
  • Sta-Clene® Formula 940 Soil & Stain Repellent

    Protect Stone, Marble, Grout and Soft Surfaces from Spills and Stains

    Sta-Clene Brochures Item # 40110
    • Sta-Clene is a solvent-based fluorochemical formulation with exceptional oil, water and soil repellency.
    • Sta-Clene contains no silicone.
    • Provides a barrier to dry soil and spills of water-and oil-based materials.
    • Reduces soiling and staining. For stone surfaces such as marble, travertine, slate, limestone, granite, terrazzo, sandstone, mexican tile, saltillo, pavers, non-glazed ceramic tile, non-glazed porcelain tile and non-epoxy grout as well as soft surfaces.
    • Not for use on epoxy grout, leather, vinyl, rubber, VCT, laminates, wood or solvent-sensitive surfaces.
    • May also be used on soft, absorptive surfaces.


    May not be shipped by air!

    Do not dispose of Sta-Clene or any other solvent-based products into drains. Keep away from fire, open flame and sparks.


    NOTE: Some smoke alarms are very sensitive and may go off when spraying Sta-Clene.


    • Ready to use. For porous hard and soft surfaces.
    • Test before using.
    • Apply in a fine mist using a less than 60 psi airless pressure sprayer. Do not aerosolize or mist into the air. DO NOT USE A POWER SPRAYER!
    • When applying Sta-Clene, use a solvent-resistant water-free sprayer such as Bane-Clene's Stainless steel sprayer. (see Related Products at the bottom of this page)
    • May also be applied with a microfiber applicator.
    • Coverage: 200 - 300 sq. ft./qt.
    • On stone and grout, be sure surface is dry before applying. Allow to soak in and then remove excess by wiping off with towels or bonnet - do not leave on the surface.
    • On glazed ceramic tile, after applying & before drying, squeegee excess into the grout before the product dries Remove from the glazed tile with towels or bonnet before the product dries.
    • Reapply after any deep cleaning.
    • May also be used on soft, absorptive surfaces.
    • Clean pressure sprayer daily.



    • Use only in open, well-ventilated area.
    • Keep vapors from extreme heat or open flame.
    • Avoid breathing vapor or spray mist.
    • Avoid contact with eyes or skin.
    • Remove any pets and small children from area until surface is dry.


    Related Articles:

    Use Concentration:Undiluted.
    Coverage:200 - 300 sq. ft./qt.
    Use pH:Not applicable to solvents.
    Dry Time:Usually 30-60 minutes.
    Full-Cure Time:Usually 24 hours.